24g Happymodel Mobula7 1S 75mm Whoop FPV Racing Drone ELRS BNF/PNP w/ RS0802 20000KV Motor Runcam Nano3 Camera COD [1931037]

Home/ Toys Hobbies and Robot/ RC Drones/ FPV Racing Drone/ 24g Happymodel Mobula7 1S 75mm Whoop FPV Racing Drone ELRS BNF/PNP w/ RS0802 20000KV Motor Runcam Nano3 Camera COD

Item Description
Customer Reviews
Payment & Shipping

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle's details below.

Select
Make:
Select
Submodel:
Select
Engine:

This part is compatible with vehicle(s).Show all compatible vehicles 1

Year
Make
Model
Submodel
Trim
Engine

Happymodel Mobula7 1S Micro FPV Whoop Drone
- X12 5-IN-1 AIO flight controller built-in 2.4G ELRS V2.0 and Openvtx- VTX Power up to 400mw - ELRS V2.0 Support- NEW RS0802 20000KV motors- Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera - Smooth and powerful- Compatible for 1S Lipo/LIHV- Recommend 1S 450mah/550mah/650mah battery (Not included)
Specifications:

	Mode: RS0802 KV20000 Stator Diamter:8mm Shaft Diameter:Φ1.5mm Weight(g):2.0g
Propellers	Material:PC Props Dia:40mm Center Hole Dia:1.5mm
	X12 ELRS V1.0 flight controller built-in ELRS 2.4G receiver CRAZYBEEF4SX1280 Target: X12 Flysky V1.0 flight controller built-in SPI Flysky 2.4G receiver CRAZYBEEF4FS Target: MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Mount hole size: 25.5mm*25.5mm Built-in 12A(each) Blheli_S 4in1 ESC Built-in 5.8G OpenVTX 0mw~400mw Built-in voltage detection
Onboard 4in1 ESC	Current: 12A continuous peak 15A (3 seconds) Factory firmware: Z_H_30_REV16_7.HEX Support Bluejay firmware
Onboard SPI ExpressLRS 2.4GHz Receiver ( 2.4G ELRS Receiver Version)	ExpressLRS Firmware version: V2.0 Antenna: SMD antenna Receiver protocol: SPI ExpressLRS Couldn’t flash separately ExpressLRS firmware
Onboard Frsky SPI D8/D16 receiver compatible ( Compatible Frsky Receiver Version)	Compatible Non-EU transmitter D8 model No ground interference ( Transmitter and receiver 1 m from the ground): 200meter
	SPI BUS receiver Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) Failsafe support
	Full UART1 for external Receiver IR1 pad(invert RX1) used for SBUS input
	Firmware version: OPENVTX PIT Mode support Channels:48ch Power supply: DC 5V
Runcam Nano3	Image Sensor: 1/3" CMOS Lens : 2.1mm(M8) FOV 150° S/N Ratio: >50dB Auto Gain Control (AGC): Auto D-WDR: Auto Power:DC 3-5.5V Housing Material: ABS Dimensions: L14mmW14mmH9mm
(Not included)	Capacity: 650mAh Continuous Discharge Rate: 30C Size: 60mmx18mmx8mm Connector: PH2.0 Product Link

1x X12 ELRS V1.0 flight controller built-in SPI ELRS 2.4G receiver
Option2:
1x X12 Flysky V1.0 flight controller built-in SPI Flysky 2.4G receiver
Option4:
4x RS0802 KV20000 brushless motor

1x Runcam Nano3 1/3 CMOS 800TVL camera

1x 1S parallel charging board

1x Extra camera canopy

24g Happymodel Mobula7 1S 75mm Whoop FPV Racing Drone ELRS BNF/PNP w/ RS0802 20000KV Motor Runcam Nano3 Camera COD

Credit Card

1, Please key in the correct shipping address in English while checking out with PayPal. Or the order will be shipped to your PayPal address.
2, If your home address (habitually receiving address) has been changed, please edit your PayPal address in time to avoid editing receiving address repeatedly while checking out with PayPal.
3, Normally, dropshipping order will be shipped out in 1 business day and non-dropshipping order 2 business days.

Shipping Method

Item	Area	Delivery time	Delivery time
Item	Area	Delivery time	In Peak Season
Standard	United States, Canada	15-20 calendar day	25-30 calendar days
	Australia, New Zealand, Singapore, Vietnam, Malaysia, Israel,Indonesia, Turkey	20-25 calendar days	30-35 calendar days
	Russia, United Kingdom, France, Spain, Germany, Netherlands, Spain, Ukraine, Japan, Belgium, Denmark, Finland, Ireland, Norway, Portugal, Sweden, Switzerland	25-30 calendar days	35-40 calendar days
	Italy, Brazil, Argentina, Chile, Mexico	30-40 calendar days	40-50 calendar days
Priority	United States, United Kingdom,Russia,Australia	7-15 calendar days	15-25 calendar days
Express	3-7 calendar days worldwide