Happymodel Mobula6 ELRS 1S 65mm F4 AIO 5A ESC ELRS Receiver And 5.8G VTX Brushless Whoop FPV Racing Drone BNF w/ 0702 26000KV Motor RunCam Nano 3 Camera

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle's details below.

• Select
• Make:
• Select
• Submodel:
• Select
• Engine:

This part is compatible with vehicle(s).Show all compatible vehicles 1

• Year
• Make
• Model
• Submodel
• Trim
• Engine

Introduction:

AIO Flight controller with ELRS Receiver and 5.8G VTX

Equipment with the lightest brushless motors-SE0702 only 1.46gram

Smooth and powerful

Brand: Happymodel

Item Name: Mobula6 ELRS 1S 65mm Brushless whoop drone BNF version

Size: 80mm*80mm*37mm

Voltage:1S

Version		915MHz ELRS
Color	Green ( Change into Blue from July 29, 2023)	Blue
Flight controller	ELRS F4 2G4	CrazyF4 ELRS	CrazyF4 ELRS
Firmware target	CRAZYBEEF4SX1280	CRAZYBEEF4DX	CRAZYBEEF4DX
Built-in ExpressLRS receiver	SPI 2.4GHz	Serial-base 915MHz	Serial-base 868MHz
Built-in Dshot ESC	5A	5A	5A
Receiver antenna plug	SMD ceramic antenna	IPEX MHF3	IPEX MHF3
Onboard VTX power	25mw~200mw	25mw~200mw	25mw~200mw
Brushless Motor	0702 KV26000	0702 KV26000	0702 KV26000
Propeller	HQPROP 31mm Bi-blade	HQPROP 31mm Bi-blade	HQPROP 31mm Bi-blade
Battery	1s 300mah Lipo battery	1s 300mah Lipo battery	1s 300mah Lipo battery

	Configu-ration:9N12P Stator Length:2mm Motor Dimension(Dia.*Len):Φ9.5mm*14mm No.of Cells(Lipo):1S only
Propellers	HQprop31mmx2 Prop Disk Diameter:31mm Weight:0.2g
Flight controller	ELRS F4 2G4 flight controller built-in SPI expresslrs 2.4G receiver CrazyF4 ELRS flight controller built-in 868MHz expresslrs receiver Sensor: MPU-6000 or ICM20689 or BMI270.(SPI connection) Power supply: 1S battery input (DC 2.9V-4.35V) Built-in Betaflight OSD(SPI Control) Built-in ExpressLRS 2.4G/915MHz/868MHz receiver Built-in voltage detection
Onboard 4in1 ESC	MCU upgraded to EFM8BB21 Support BLHeliSuite programmable Default protocol: DSHOT600
Onboard SPI ExpressLRS 2.4GHz Receiver (Optional)	Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz Telemetry output Power: <12dBmReceiver protocol:  SPI ExpressLRS
	Rx To FC protocol: CSRF RF Frequency optional: 915mhz or 868mhz(EU) Antenna connector:  IPEX4 Could bind with Happymodel ES915TX , Frsky R9M and DIY ELRS TX module(need to flash the same version ELRS firmware)
	Frequency: 40CH Current consumption: 300mA(type) With RacebandSmartaudio ready
Runcam Nano3	Model: RunCam Nano 3 Horizontal Resolution: 800TVL Signal System: PAL/NTSC Non Switchable Electronic Shutter Speed: Auto Min. Illumination: 0.01Lux@1.2F Day/Night: Color Current: 110mA@5V 120mA@3.3V Net Weight: 1.2g
	Voltage:3.8v Size: 57mmx12mmx7mm

Package Included:

1x ELRS F4 2G4 flight controller built-in receiver